ExtremeSwitching (EXOS/Switch Engine) - Page 125 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! X690 stack stopped responding to SNMP earlier in the month

Went to research some bandwidth utilization on a x690 core switch stack in cacti and notice the graphs are all blank. Upon further diagnosis this seemed to occur between 9/30 and 10/3 with graphs slowly loosing resolution. Verified with the diagnos...

VxLAN vs GN3

Hi folks, I'm doing a LAB with VxLAN using GNS3.I configured ospf extensions or, If I configure static to the remote VTEPs and even so it's not working well. The results are below:* DC1LEAF1.1 # show ospf lsdb opaque-global Opaque Glo...

STP and MVRP auto binding

Hello Nine month ago I asked for help related to Dynamic Vlans and STP. https://community.extremenetworks.com/extremeswitching-exos-223284/dynamic-vlans-and-stp-7761542 Stephen Williams warned us that STP does not support dynamically created VLANs...

VLAN port management command syntax

Hi all, Newbie networking guy hereI can’t seem to nail down the syntax for our 450-series switches. I’m a Cisco guy and used to say:Switchport access vlan 15Switchport access voice vlan 2That switchport is now a member of the data vlan and the voice ...

Resolved! show ports vlan name?

When I run the show ports no-refresh command I see all my listed and when I look down the VLAN column some of my ports list a reference number (not the VLAN id) and others show the actual VLAN Name associated to it. This switch was setup by an engin...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN