Hi all, Newbie networking guy hereI can’t seem to nail down the syntax for our 450-series switches. I’m a Cisco guy and used to say:Switchport access vlan 15Switchport access voice vlan 2That switchport is now a member of the data vlan and the voice ...
When I run the show ports no-refresh command I see all my listed and when I look down the VLAN column some of my ports list a reference number (not the VLAN id) and others show the actual VLAN Name associated to it. This switch was setup by an engin...
Hy,we have the following setup in our companyTwo x590 stacks “TOP” and “BOTTOM” as CORE switchesTwo X440G2 stacks as copper Switches for Management devices “ILO, IDRAC, etc” Is the sharing algorithm important on the MLAG ISC port? https://extremeport...
Hi, I want to permit selected subnets and deny all other subnets ingress traffic to our PBX vlan. I configured ACLs shown below. But I can still access to PBX VLAN (web pages of IP phones on PBX VLAN) from every where. What shoul be the problem? PB...
Hi, i have a problem with mpls. After i had it configured, switch was rebooted with message:<Warn:DM.Warning> Switch FAILED (1) Process Failure09/29/2021 21:44:12.42 <Erro:DM.Error> Node State[4] = FAIL (Process Failure)09/29/2021 21:44:12.42 <Warn:...
