Hello, I would like to know how to make several vlan share the same bandwidth (meter) on the ACL. Are the following commands sufficient? ACL_VLAN1 : # RuleNo# 6entry rateLimitOut { if match all { source-address X.X.X.X/30 ;} then { meter mt...
I have a server connected to VDX-6740 HW in a 802.3ad LAG setup with 2 Ethernet links (Not sure about the exact setup. I am a user of your products, not the admin).I would like to have some control over the load balancing. For outgoing messages, it i...
Hello,one of our switches showed a high cpu utilization and after a short look it seemed that someone sends SNMP requests without or with wrong authentication:SNMP stats:InPkts 10230358 OutPkts 10230357 Errors 10188902 AuthErrors 10188902Gets 101...
In EXOS, what command would be the equivalent of forbidding multicast traffic out an uplink port? Basically disabling the mrouter port, but not the interface. (Picture of a Cisco switch example) I have a vlan that runs video only and it is contained...
I have a new 2 switch stack of 5520’s each with VIM-4X in the right side. I have 2 10gbps fibers that work perfectly in a load sharing to connect to another floor, and 2 Active Twinax to a vmware server in a load sharing link working perfectly.I hav...
