Resolved! ECCN and HTS code
Hello, Appreciate if someone can provide me the ECCN and HTS codes for the Extreme Summit switch X430-24t. Thanks heaps. Ralph
Forum Posts
Resolved! GARP in EXOS
Good afternoon, the GARP protocol is supported by EXOS versions? I have two Avaya SBCs in redundancy, and when making the switch it sends the GARP message but the FDB entry is stuck in the source port and it does not go to the destination port, can y...
Speed Negotiation
Hi Team, I am using x670-48t switches and all of the ports available are of 1G/10G speed.But the device with which I want to connect has a port of speed 100 mbps. When I am trying to downgrade the port speed to 100 mbps using command : configure po...
Resolved! ipforwarding were disabled in VMANs after the comand enavle ipforwarding (without any vlan)
HiYesterday we had an unexpected result after configuring the exact command “enable ipforwarding” in our Switch Extreme Netowrks X460-G2-48X-10G4, it was supossed that all vlans would enable ipforwarding but instead all vmans were ipforwadingg disabl...
Problem with Cisco and Extreme Switch
Hello everyone!Hope you all are fine and healthy. I have been working with the configuration of some Cisco APs connected to a Cisco switch / Switch Extreme for three days. However, so far, no success in this task. As a result, I decided to raise my h...
