ExtremeSwitching (EXOS/Switch Engine) - Page 177 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Using UDP Profiles for PXE Boot

We currently use a UDP Profile for DHCP and DHCP Fingerprinting. In terms of using it for PXE boot is it just a case of adding a few more lines of text to include the PXE server? I believe its 4011, pxe port. see below our current udp profile ent...

Resolved! MLAG with multiple Virtual-Routers

I have some x690 switches with multiple Virtaul-routers and VLANs that I need to connect to x670s. Do I need multiple ISC links to do this? An ISC link on each virtual-routers?

Extreme NAC Removal

I’m trying to remove one of my switches from NAC. I’ve removed the switch from NAC, and removed most of the configuration information from the switch but I can’t seem to remove the following configuration for all of my ports. I’ve tried the typical “...

Resolved! Does extreme x670-g2 support pvst protocol?

At one of the customer site, I need to migrate 2 nos of cisco 6500 series routers to 2 nos of extreme x670-g2.Existing customer network is configured with spanning tree protocol PVST. So does extreme x670-g2 support pvst protocol? If not then for thi...

Equivalent EXOS commands required for following cisco commands

service nagleno service padservice tcp-keepalives-inservice timestamps debug datetime msec localtime show-timezoneservice timestamps log datetime msec localtime show-timezoneservice password-encryptionservice linenumberservice sequence-numbersservice...

Top Kudoed Authors

User

Count

28

26

18

18

17

GTM-P2G8KFN