ExtremeSwitching (EXOS/Switch Engine) - Page 183 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Port Scanner shows a wide range of ports blocked which the customer requires to be open for scanning.

No ACL has been configured but a lot of the ports have been scanned and are found to be blocked. See excerpt below.I believe if you dont configure any ACL, all ports should be open by default. Is there any relevant documentation that lists all the po...

Resolved! Can 460 series switches send VLAN information using LLDP TLVs to the end devices?

We are trying to display Vlan information when troubleshooting a port using Netscout LinkRunner AT 2000, Here is the configuration on the port we are testing, we are able to get the switch port and IP, but not the Vlan. configure lldp port 2:6 advert...

Cisco IP Phones 7900 Series

Hello Heroes we have a switch X450-G2-24p that need to be use in one of remote sites which has already Cisco IP Phones (8800) and (9712,9740) deployed in their network, so we have configured the switch and apply the needed commands especially for the...

Resolved! EXOS | Mac-Locking vs Limit-learning/Lock-learning

Hello,We’re trying to upgrade our security level in the Access layer where we have EXOS stacks.So, I was thinking to use Mac-locking to achieve our goals, because it is something that we already used in another customer, so, it’s very familiar.Howeve...

Resolved! Does x670-g2 requires additional license for BGP configuration?

At one of the customer site, I need to migrate 2 nos of cisco 6500 series routers to 2 nos of extreme x670-g2.Existing customer network is configured with following BGP configuration. Do I need CORE license in extreme x670-g2 for this or base license...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN