ExtremeSwitching (EXOS/Switch Engine) - Page 271 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Change from Bootprelay to udpfwd profile , caused DHCP to be unstable , where some clients receive an IP address from the DHCP server.

Change from Bootprelay to udpfwd profile ,for specific vlans to support PXE boot , this caused DHCP to be unstable , where some clients receive an IP address from the DHCP server , while others do not , while on teh same network . Looking at the DH...

Redirect traffic with acl

I have a switch core x460 with some vlans, one of then is 10.10.22.0/24, I created an acl and applied on vlan (10.10.22.0/24), to redirected traffic to other gateway. Why the packet ignore the all route table ? When I applied the acl the traffic is s...

Looking for 1/10G access switches with 1G uplinks

Hello Extreme Community! I'm new to the Extreme industry and I'm looking for a switch that provides 1/10G access with 1G uplinks ( we have a limitation in terms of our firewall models being used for the design- must be 1G) I would love to hear the...

Routing anomalous between VLAN

You can not understand why a PC (IP 192.168.10.130) of a vlan31 pings another PC (IP 192.168.4.66) of a vlan40 We all have enterasys switches series B5 and extreme networks and in theory there is one of these switches that acts as a routing but if I...

Resolved! How many V400 can be connected to a single VX-RPS-1000

Hello, we want to setup V400 switches with a VX-RPS-1000. What ratio does the RPS serve? Is it a 1:1 per V400 switch or can I connect more than one switch to the RPS? Thank you

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN