ExtremeSwitching (EXOS/Switch Engine) - Page 286 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! can we stack x690 100G using the transceiver - 10 0Gb, DAC QSFP28-QSFP28 0.5m

Hi, Can we stack x690 using the transceiver - 10 0Gb QSFP28 LR4 10 km or DAC cable --- 10 0Gb, DAC QSFP28-QSFP28 0.5m ----- 100G stacking required.

Port congestion drops, microbursts or something else

Hi BD X8 chassis, BDXA-10G48X module, sw 15.5.2.9 A port operating as 10G is displaying about 2500-4000 pps constant drop rate with "show port congestion" command. At the same time "show port util" is displaying 13% peak TX BW. The cause for such ...

Resolved! Configurations changes log

Hello, I tried to find on EXOSCommandRef, but I didn't find. Is there a file where I could find confs modifications? Thanks a lot.

Change from Bootprelay to udpfwd profile , caused DHCP to be unstable , where some clients receive an IP address from the DHCP server.

Change from Bootprelay to udpfwd profile ,for specific vlans to support PXE boot , this caused DHCP to be unstable , where some clients receive an IP address from the DHCP server , while others do not , while on teh same network . Looking at the DH...

Redirect traffic with acl

I have a switch core x460 with some vlans, one of then is 10.10.22.0/24, I created an acl and applied on vlan (10.10.22.0/24), to redirected traffic to other gateway. Why the packet ignore the all route table ? When I applied the acl the traffic is s...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN