ExtremeSwitching (EXOS/Switch Engine) - Page 30 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! PTPv2 vs. gPTP

Hello there,am new to Extreme Networks. I see in Switch Engine v33.11 User Guide that:The Precision Time Protocol is currently available only for version 32.6 and later releases on ExtremeSwitching 5520 series switches, and version 33.1.1 on 7520-48Y...

No resource for ACL even that slices are free x670-G2 stack

I am on version 31.7.2.28 and am trying to set or refresh an ingress ACL on a port without success. I receive the message: *"Error: ACL install operation failed - vlan , port 1:12, rule 'group65', No resources for operation."In earlier versions, we o...

Error: Refresh failed for policy xxx - ACL install operation failed

Hello community,trying to refresh one of our policies, but I am getting this error. Have you met similar problem? I tried to find out, what this error means. But without success. Error: Refresh failed for policy 'xxx'- ACL install operation failed -...

Can we put multiple source address in the Access list polciy

can we make access policy with multiple source address since i am trying to do this but it is giving error in policy check

Resolved! Firmware double check on device

Hi, anybody here who can tell me the CLI command and the place where a new Firmware is stored?Something like (dir Flash: from Cisco) i am not able to verify that the new firmware is stored on the device (x440-g2)aprreciate your helpKR Uwe

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN