ExtremeSwitching (EXOS/Switch Engine) - Page 318 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

GRE tunnel forwarding not working

I have created a GRE tunnel between a 460g2 and another device. I have configured a /31 on the GRE tunnel. I have enabled forwarding on the GRE tunnel. I am only able to ping the remote side of the tunnel from the 460 itself. I can ping using its IP...

mirroring unicast traffic in vLAN

When I mirror several vLANs toward a port, I can see all broadcast traffic but no unicast traffic. It's a little bit like if the monitoring port had been inclded in the vLANs mirrored but no mirroring happen at all... Is there some configuration I mi...

MSTP Configuration Question

I am looking at a configuration provided to me by a client on an existing Extreme switch. They are needing me to translate this configuration to a Cisco configuration. The configuration from the Extreme switch shows: configure mstp region 00049635f7...

Fails to login to BD8806 after power modules failed & replaced.Bootrom Factory setting reset not working

I have a BD8806 that i'm unable to login after power modules failed and replaced by some new ones.I'm suspecting it lost some configs during the fault because all the users are unable to login using the console. Tried to reset to factory settings usi...

Maximo de rutas estaticas en switch X460-G2

Greetings, I would like to know which is the maximum static routes that an X460-G2 switch supports and if it depends on the EXOS image that the equipment has?

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN