ExtremeSwitching (EXOS/Switch Engine) - Page 414 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

vlan over snmp

Hi. Im try to create vlan over snmp - i understand that it must be in EXTREME-VLAN-MIB. there is: extremeVlanIfIndex 1.3.6.1.4.1.1916.1.2.1.2.1.1extremeVlanIfVlanId extremeVlanIfVlanId 1.3.6.1.4.1.1916.1.2.1.2.1.10 extremeVlanIfDescr extremeVlanIfDes...

Telnet connection from core switch sub-switch

Hello I have a extreme core switch (A) where an lwl cable is connected to another switch (B) (uplink port) The switch (B) has no ip address yet. I can only access the switch if I connect directly with a notebook via the management port. I can acc...

Extreme X460 - X670 CFM | Hardware vs Software Session Type

I've configured a back to back CFM domain between an X460-48x and an X670V-48x, created the association and added the remote rmep and lmep. X670V-48x Review configuration below: create cfm domain string "Access" md-level 2 configure cfm domain "Ac...

Transit ACL on L3 routing switch

Does anyone happen to have a transit ACL on a publicly routed ExOS switch? I'm using an X440 stack as an internet gateway for a customer. I did create an access profile for all of the management profiles only permitting certain IP ranges to gain a...

Netlogin - Dot1X and Mac authentication on the same port

I have netlogin successfully working with 802.1x and MAC-based when a single device is connected. I am now trying to combine this in the form of an Avaya handset - a port is configured with Netlogin: - tagged VLAN for voice (with MAC auth) - untagge...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN