ExtremeSwitching (EXOS/Switch Engine) - Page 422 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

VPLS+MLAG+ISC

Hi all. Config. We have two X670 with MLAG and MPLS/VPLS enabled, some ports use MLAG. We have shared group of 4 ports for ISC link between switches, also have customer vlan V100 on both switches, vlan V100 does not added to any MLAG ports, only to...

Spanning Tree MSTP region and general STP question

Hi all, I’m getting ready to decommission some Summit x450e’s and replace them with x460-G2’s. As I’m not very familiar with MTSP or Extreme in general and I’m looking for a little assistance. My plan is to create a trunk between the new 460 stack...

x460-g2 swtich failed again and again

is anyone help...i have x460-g2-48p and x440-g2-24p and both are in stacking... but x460 switch failed 4 times,,i rasied request from RMA i got new switch and configured the same, its working for one month then again failed.. this issue happen 4 time...

problems with ip route default

Hello. I have a route table. All routes are directed to 10.106.0.1 as the default route, but I would like to route a single VLAN to another route. Could you please tell me about the things I need to do about the subject? Thank you. Ori Destination...

Address is on the same network as VLAN port_1_vlan!

I want to configure ports like - 192.168.1.x/24 but i have a problem, from 2nd and above vlan, it tells me "Address is on the same network as VLAN_port_1_vlan!" Commands i'm using: configure Default delete ports 1-48\r create vlan port_1_vlan\r co...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN