ExtremeSwitching (EXOS/Switch Engine)
Questions and discussions about EXOS
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Learn stack in Extreme Cloud IQ

Hello.I have a question. I form the Stack by CLI, for example 3 Switch, I connect the Master of the Stack to the internet and I upload this MASTER to the Extreme Cloud. only with this master SW connected to the internet does the other two Switches fo...

Ruben2 by New Contributor
  • 876 Views
  • 1 replies
  • 0 kudos

Question on vLAN tagging

HiI’m a little rusty on tagging so just after some thoughts from esteemed members.Setting up a firewall with sub-interfaces so only one connection from switch to FW interface.   Default route is configured on the switch.However the setup I have is no...

Jasp80 by New Contributor
  • 1538 Views
  • 3 replies
  • 0 kudos

Use Config command

TFTP finishes and says done. When I issue the use config command I get ^ at first character of config file. Doesn't matter what the file name is. Config or any backup config file. What am I missing here? This should be simple.....

MtnManBo_0-1681507974896.png MtnManBo_1-1681508107262.png
MtnManBo by New Contributor
  • 1145 Views
  • 2 replies
  • 1 kudos

MVR doesn't work on X435

Hi all!I have one X435-24P-4S, to which I connected two PCs; on port 1 there is a sender with VLC streaming video on multicast address 239.1.1.1; on port 2, receiver with VLC listening on the same multicast address. Both have unicast IP addresses:Sen...

GTM-P2G8KFN