ExtremeSwitching (EXOS/Switch Engine) - Page 514 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

What are the Command to passtrough Customer-LACP through an Extremeswitch with sw 22.1

Setup: Point to Point connection with two Extreme x620. We have setup a VMAN for transparent Service. Customer use LACP on both end that we have to transport from A-Switch to the B-Switch. Now the LACP goes not trough by the Extreme with an VMAN? C...

ExtremeXOS 22.1 is now Available!

Hi Team, It is my pleasure to announce the availability of ExtremeXOS® 22.1. We hope you are excited about this new ExtremeXOS® 22.1 release! This helps with the following: Enable New Revenue Opportunities Common Criteria Readiness - Common Criter...

LAG between stack members with different port speeds

Hi all, Here's an annoying LAG problem. I have a stack which consists of an X670-G2 (slot 1) and an X460-G2 (slot 2). I want to create a 4x 1G LAG from this stack to another switch elsewhere. We're running 16.1.3.6 on this. Unfortunately, this i...

IPv6 address on VLAN error

Getting error while trying to assign IPv6 interface to a vlan. IPv6 forwarding is already enabled on the VLAN, along with port tagging. Getting error as below:- %% Invalid input detected at '^' marker. %% A number within the range of 1-4094 is expe...

Are other SFPs vendors can be used with Summit switches ?

i have some Summit switches, and we wan to use SFPs LX of other vendors Cisco or Juniper. Can summit switches support other SFPs vendors ?

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN