ExtremeSwitching (EXOS/Switch Engine) - Page 515 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Upgrade EXOS 16.2 for BD 8800 MSM-48c

Hi expert, We are going to upgrade EXOS from release 15.3.2.11 to 16.2.1. Current HW is BD 8800 MSM-48c. Please advise if release EXOS 16.2.1 does support current HW MSM-48c? And anyone already do upgrade it? please share your experience Thanks!

Why is the default for iparp max entries 8192?

It seems that user traffic would be negatively affected if entries are not stored because the configured max is too low. We recently began looking at some networks that were at the cap 8192, so we increased the cap to 16284. After the increase we fo...

What are the Command to passtrough Customer-LACP through an Extremeswitch with sw 22.1

Setup: Point to Point connection with two Extreme x620. We have setup a VMAN for transparent Service. Customer use LACP on both end that we have to transport from A-Switch to the B-Switch. Now the LACP goes not trough by the Extreme with an VMAN? C...

ExtremeXOS 22.1 is now Available!

Hi Team, It is my pleasure to announce the availability of ExtremeXOS® 22.1. We hope you are excited about this new ExtremeXOS® 22.1 release! This helps with the following: Enable New Revenue Opportunities Common Criteria Readiness - Common Criter...

LAG between stack members with different port speeds

Hi all, Here's an annoying LAG problem. I have a stack which consists of an X670-G2 (slot 1) and an X460-G2 (slot 2). I want to create a 4x 1G LAG from this stack to another switch elsewhere. We're running 16.1.3.6 on this. Unfortunately, this i...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN