ExtremeSwitching (EXOS/Switch Engine) - Page 555 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Aastra VOIP phone and ELRP

Hi All, We are currently struggling with an issue which appears to exist between our Extreme edge switches and certain models of VoIP phones. Basically, despite having ELRP configured, if a user creates a loop by plugging both the PC and LAN ports...

How to configure EAPS with CFM/OAM?

How can I configure CFM/OAM basicly between 2 switches and together with EAPS for faster ring recovery, when I have a thrid-party switch in ring? I read user/concept guide, command reference guide and older ENA/ENS Guides, but this doesn't help my. C...

Negotiating Ethernet and VLAN Interworking Types in VPLS

X670 connected to other VPLS capable device who can't use manual settings for vc type. When created pseudowire with tagged type, connection stay down and in dump we see label mapping messages with VC type 0x0004 (Ethernet VLAN) from other device and ...

How to make ACL that will only allow HTTP traffic to and from a specific host

I am new to ACL in Extreme and would like to seek your support on how to make an acl to only allow HTTP and HTTPS traffic to and from host 10.158.22.36. All other packets to and from 10.158.22.36 should be denied. thank you!

How to configure a port of the switch SummitX-150 to connect a vmware infrastructure with several machines on differents VLANs

I'm configuring a switch Extreme SummitX-150 Port to connect an ESXi platform on its port linked to a vswitch. the vswitch has several VMs on differents vlans. How to configure the Switch Port? Previously the switch used was a cisco 2960 and the conf...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN