ExtremeSwitching (EXOS/Switch Engine) - Page 580 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Field Notice (FN410) - X620-16t and X620-8t-2x Harmless Message 'PHY8481 reset failed

The Extreme Networks Services Team has posted Field Notice FN410 - X620-16t and X620-8t-2x Harmless Message 'PHY8481 reset failed on the GTAC Knowledge website. If you have any questions concerning the release of this Field Notice, please contact yo...

X350-24t strange behavior with speed ports

Hello, all! have X350-48t with connected lap-top. When port speed is auto - all normal When configure port as 100 duplex full - speed is very decrease Try with SpeedTest, below results: autonegotiate as 100 full - speedtest=95Mbps configure as 100...

Edit SNMP config

Hi! i need edit snmp config at the sw. I have this configuration "configure snmp access-profile snmp_access1 readwrite" and want chenge to readonly: "configure snmp access-profile snmp_access1 readonly" but i see a CLI error: Error: Please remove...

Mirror with access to the probe

Hello, I'm searching a way to allow data on one client vlan on a mirroring destination port. This is for keep a distant remote session on the probe (for example, TSE, SSH or VNC session). Do you know if it's possible with Extreme Networks Summit ...

Accessing An ExtremeXOS Switch When Admin Credentials Are Unknown

Forgotten passwords happen - Here's a helpful guide on EXOS password recovery. It will work on EXOS 12.1 or greater. This procedure does not work for EXOS Summit switches with BootROM version 2.0.2.1 as the code:config none command is not present...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN