ExtremeSwitching (EXOS/Switch Engine) - Page 618 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Ospf is not filling route table

I've been using a switch extreme x460 24pt in my lab, and i'm setting up OSPF, so when the ospf is running and up, the sw is not able to filled the route table with the routes received from the another router as if they doesn't exchange router table....

MAC move seen in Cisco switch connected to Extreme

Okey but I have other question and I have Cisco 3650 L3 end two xos summits 430 24t connecting trunk connection. Cisco L3 say flopping extreme switch connecting ports to vlan 1. What recommend give me about that. Note: This conversation was created...

Routing to a DHCP wan address

I am new to configuring extreme switches and have no idea if this is even possible, but here is what I would like to do. I have an extreme networks summit x460-24T What I would like to do is use it to route several vlan networks to a WAN/ internet n...

qinq

Hi Team, I have configured qinq in extreme switch. Getting incoming packets with qinq tagging. I configured vman on the switch and assigned ingress and egress ports one with tagged(ingress) other one with "cep cvid" (egress). I am seeing egress...

show ip accounting

What is the EXTREME NETWORKS command as " show ip accounting" of CISCO

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN