ExtremeSwitching (EXOS/Switch Engine) - Page 640 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Extreme XOS STP setup with existing Enterasys network

When I loop a switch, I want the port to go down and stay down. This doesn't work in 16.1.2.14-patch1. The port comes back up and loops the network after a few seconds. These x460G2's are integrating with an existing Enterasys network with one MST...

QoS marking on CPU sourced packets

Here's a scenario where I can't quite work out if what I'm trying to do is even possible, let alone how to do it... Imagine you have two switches (in this exact instance, I have an X460 at both ends) that are used to terminate a fibre link between t...

OSPF on X440 Edge Core

Hi. Can I make work OSPF in a X440 network? I have 3 X440, two on remote locations, and one in HQ. I have configured the OSPF by this way: Switch "80": configure ospf routerid 0.0.0.80 create ospf area 0.0.0.1 configure ospf add vlan VLAN_A area 0....

What is meaning of "Enabling diffserv examination will cause dot1p replacement of 802.1q tagged packets."

What is the meaning of the below Warning? Warning: Enabling diffserv examination will cause dot1p replacement of 802.1q tagged packets. It seems to imply that when using tagged packets, using 802.1p, when enabling diffserv examination those tagged p...

Only one MSM is seen in BD 8806

in extreme BD 8806, io can see only one MSM, only MSM B is showing master..s there any specific reason

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN