i would like to check the user IP that connected on my switch .i can access my switch through putty i know that which port is up through NMS know i would like to know that which user is connected on my that switch.
Hi guys, When use this command "configure stacking {node-address node-address | slot slot-number} license-level [core | advanced-edge | edge]"? I read the manual but I didn't find any explanation.and examples. Thanks in advance, Edson Moura
Customer plan to have separate VLAN on the switches for IPs from different segments. Each segment is not suppose to see each other. Also need to stack the switches for HA purposes. Below are their plan architecture. Is your any expert able to advice...
Hi everyone, New to extreme switches coming from the Cisco side.... I'm trying to configure RSTP between my extreme switches and Ruggedcom RS900 switches. However, when I try to enable my stpd domain, I get the following error: Error: Incorrect ca...
Configuration Port ? which command can make same configuration Port same another port previously prepared?
