ExtremeSwitching (EXOS/Switch Engine) - Page 648 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

SFP SX insert to 4-port SFP+ 10GbE (XGM3S-4SF Module) on X460-48t switch

Hi all, I have X460 with XGM3S-4SF Module. From the description on the datasheet mentions : XGM3S-4SF 4-port 10 Gigabit Ethernet module, provides four SFP+ ports. These four SFP+ ports can support both 10 Gigabit Ethernet SFP+ transceivers and Gi...

When creating a vlan, I get a loop after 1 hour in network. How can I check it?

hello Guys , I have added new switch type Summit X450-24x DC in my network , when i creating any Vlan after 1 hours loop happen in network , why that happened , Is there commanded or method to shows me where the defect was?

One member of LAG is in a Defaulted State.

Hi Everyone, I am having a LACP LAG issue between two extreme switches. Extreme X460 and Extreme X440. Physically I get a link light on all 4 ports. However when looking through the cli I get the following output Floor 7 Slot-1 SWStack_FL7.1 # show...

BGP passive neighbor

Hello Extreme Team, do you have any plans to add a BGP passive neighbor configuration to EXOS? -- Jarek

Cisco SFP not connecting, shows signal, but with a fault

Hello, I have an Extreme X450-G2-48P-GE4 which I am linking to a Cisco 3750 series switch using two Cisco SFP 1000base SX modules (GLC-SX-MM). I am running ExtremeXOS version 16.1.2.14. I have no link lights, and no errors in my logs. When I pull a...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN