HiI’m a little rusty on tagging so just after some thoughts from esteemed members.Setting up a firewall with sub-interfaces so only one connection from switch to FW interface. Default route is configured on the switch.However the setup I have is no...
Hi,As the topic,From which version of EXOS it is possible to check bits send/receved via snmp (Stack Ports)?Thank you in advance,
TFTP finishes and says done. When I issue the use config command I get ^ at first character of config file. Doesn't matter what the file name is. Config or any backup config file. What am I missing here? This should be simple.....
Hi all!I have one X435-24P-4S, to which I connected two PCs; on port 1 there is a sender with VLC streaming video on multicast address 239.1.1.1; on port 2, receiver with VLC listening on the same multicast address. Both have unicast IP addresses:Sen...
Hi Community,after the last upgrade to 31.7.1.4 patch 77 the logs from our X440-G2 and X460-G2 Switches are full with messages like <Warn:Kern.Card.Warning> Slot-1: net_ratelimit: 106 callbacks suppressedCount is between 1 and 106.I read some gtac ar...
