ExtremeSwitching (EXOS/Switch Engine) - Page 653 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

When creating a vlan, I get a loop after 1 hour in network. How can I check it?

hello Guys , I have added new switch type Summit X450-24x DC in my network , when i creating any Vlan after 1 hours loop happen in network , why that happened , Is there commanded or method to shows me where the defect was?

One member of LAG is in a Defaulted State.

Hi Everyone, I am having a LACP LAG issue between two extreme switches. Extreme X460 and Extreme X440. Physically I get a link light on all 4 ports. However when looking through the cli I get the following output Floor 7 Slot-1 SWStack_FL7.1 # show...

BGP passive neighbor

Hello Extreme Team, do you have any plans to add a BGP passive neighbor configuration to EXOS? -- Jarek

Cisco SFP not connecting, shows signal, but with a fault

Hello, I have an Extreme X450-G2-48P-GE4 which I am linking to a Cisco 3750 series switch using two Cisco SFP 1000base SX modules (GLC-SX-MM). I am running ExtremeXOS version 16.1.2.14. I have no link lights, and no errors in my logs. When I pull a...

I want to make X450a-48t as a remote accessible as well as monitoring the switch via ssh ? How it can be done in detail ?

I want to make x450a-48t accessible from remotely from ssh ? What are the process ? I want to unconfigure vlan mgm ipaddress but it did not let me to change ? I have one text vlan which have same ip address as vlan management ? I need guidance I am s...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN