ExtremeSwitching (EXOS/Switch Engine) - Page 665 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Is Fibre Channel Over Ethernet supported on extreme Summit Switches , if it is how is it configured.

I am looking to confirm that extreme hardware ( Summit Xseries )support FCoE. If so what is it called in "Extreme speak " and how specifically is it configured,.

STP mode or default, whats the difference?

Hi there, Working on a site that has adopted an odd configuration for spanning-tree that I'm trying to make sense of. The below is an edited example taken from an edge switch. The network consists of all extreme devices. Its seems as though PVST+ h...

Summit Stack bcmDPC high cpu utilization

I have a stack of Summit 450 and 460 switches. All are running XOS 12.6.2.10 (I know it's old, but we don't pay support so can't upgrade). We regularly have a situation where the management interface (SSH or Telnet) is slow to respond. Traffic doe...

x440 stack enable sharing issue

I have an issue with LAG across stack (4x Summit x440-24t-10G stacked via SummitStack-V): Slot-3 Stack.18 # sh slot Slots Type Configured State Ports ----------------------------------------------------------------...

Configure maximum mac-addresses per port

Hello Mates, I would like to know what is the equivalent of this cisco command "switchport port-security maximum 2" Im actually working on X440-48p switches and I need to configure that. Thank you very much 

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN