ExtremeSwitching (EXOS/Switch Engine) - Page 697 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

XOS update, how to activate new version?

Hi, I just downloaded v.16.1.1.4 xos and ssh images to x440 and rebooted the switch. The documents I read says when I reboot the new firmware activates. But after rebooting it is still using ver. 15.2. So how can I use new version? Current State: ...

OEM 10Gbps Optics - Safe or not?

I'm wondering if anyone has any experience using OEM 10Gbps SFP+ optics? I'm guessing that any link issues will be met with a, "You aren't using a supported optic" response by support. Other than that, has anyone actually had any issues with compat...

How do I configure an access list to allow only one IP through ingress port?

entry iprule1 {if { source-address 10.1.2.246/32 ; } then { permit ; } else { deny ; } } I am getting error: Error: ACL install operation failed - conflicting actions And where is "Extreme Networks Policy Manager" cant find it on extremenewtwork...

Please help. I need to create a snmp community with access to only one subnet and deny others?

Please check if this is correct:- Can I apply the following policy to the snmp community :- entry iprule1 { if { source-address 10.1.2.0/24 ; } then { permit ; } } entry iprule2 { if { } then { deny; } } Or is there a simpler way?????

vlan routing on X440

I have followed the article in the GTAC on how to enable inter vlan routing and I am unable to ping the either PC in either vlan. From PC A on vlan10 I can ping the gateway and the other gateway of vlan20, and from PC B on vlan20 I can ping the gate...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN