ExtremeSwitching (EXOS/Switch Engine) - Page 71 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Stack port failed

Good afternoon,what will be a cause of the stacking port to failed, only one port of the node is down , stacking ring still up connectivity remains on the node, any commands to see what causes the error? just reboot the node? thanks

Resolved! Display Log Entries

In my EOS switches if I SSH into them and a device plugs into the switch...I see a message that says "so and so port is active"...In EXOS I have to manually type the "show log" command and then scroll all the way back to the top to see the same type ...

Extreme switch failed to use primary.cfg

hello everyone,We have an issue with some switch x450-48p and x440-24p.These switch when boot up did not load the primary configuration (that is previus saved), below the steps done:1)Boot up a switch that have factory default config2)change account ...

Software Releases

Hi,I’m a little confused on how downloading the software for these switches works. When I look up the X435 on the software compatibility page, it tells me that EXOS 31.7.1.4-patch1-36 is the maintenance release. But when I try to download this softwa...

Most common EXOS show commands and config commands

Hello Extreme Gurus, I'm coming from Aruba/Cisco envirement, and we've got to support a new customer with Full extreme switchings infra, Most of the time we stack to find the right command to troubleshooting different switching things, Thus I reached...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN