ExtremeSwitching (EXOS/Switch Engine) - Page 752 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

SNMP Vlan Total Traffic

Hello guys, I have two problems. 1st - I need to create a graph based on datas collected by snmp of full traffic about a specific vlan, then, i've enable the command "configure ports all monitor vlan XXX" at extreme x440 to i can pull the informati...

On an X450a-48t is there a way to put more than one command on the command line ? e.g. in UNIX commands can be separated by a semi-colon

On an X450a-48t is there a way to put more than one command on the command line ? For example in UNIX commands can be separated by a semi-colon

IP address conflict detection on Extreme Layer 2 switches

Is there any logging feature on Extreme devices (switches or routers) that can detect IP address conflicts (in this case, on windows machines)?

Does XOS have a feature like Cisco IP SLA ?

with Cisco IP SLA it is possible to monitor network parameters like latency, jitter and others. is there an according Extreme XOS feature ??

rc operation failed

Summit x460-48p on 15.3.2.11 getting some strange errors that I have never seen before. vrId 2 adj 0x0A3C482F Add had mixed results. 1 units succeeded, 1 failed (rc Operation failed) flags 0x8000 I was not able to find any information on this e...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN