ExtremeSwitching (EXOS/Switch Engine) - Page 753 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

How to create LAG between two X670 switches using VIM4 ports?

How do I create a LAG (lacp layer 2) between a pair of X670 switches using the VIM4 module ports? I can create one using a pair of ordinary 10G ports on the front panel and it works as shown in the manuals, but I cannot get the thing to work when a...

SNMP Vlan Total Traffic

Hello guys, I have two problems. 1st - I need to create a graph based on datas collected by snmp of full traffic about a specific vlan, then, i've enable the command "configure ports all monitor vlan XXX" at extreme x440 to i can pull the informati...

On an X450a-48t is there a way to put more than one command on the command line ? e.g. in UNIX commands can be separated by a semi-colon

On an X450a-48t is there a way to put more than one command on the command line ? For example in UNIX commands can be separated by a semi-colon

IP address conflict detection on Extreme Layer 2 switches

Is there any logging feature on Extreme devices (switches or routers) that can detect IP address conflicts (in this case, on windows machines)?

Does XOS have a feature like Cisco IP SLA ?

with Cisco IP SLA it is possible to monitor network parameters like latency, jitter and others. is there an according Extreme XOS feature ??

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN