ExtremeSwitching (EXOS/Switch Engine) - Page 759 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Using ACL to isolate all VLAN, only certain VLAN are allow to communicate.

Hi All, I have an situation, the requirement need us to isolate all VLAN, only allow certain VLAN communicate with each other. However, all VLAN shall able to go Internet. The challenge is there are OSPF in the network. Besides, there area VRRP con...

Upgrading XOS on 440-24p

Hi, I'm having some trouble connecting from my switch to my Laptop in order to perform a software upgrade. I can't ping outbound from the switch using PING VR VR-DEFAULT, I receive 100% loss. If I try to connect to a TFTP server using TFTP VR VR-DE...

STP: Changing the bridge priority of a switch

If I change the STP bridge priority of a switch to a lower value (from 20480 to 16384), using the command: config stpd s0 priority 16384, will that change take effect immediately? If not, do I need to restart stpd? disable stpd s0 enable stpd s0. ...

basic routing question

I have VLAN configured with no routing on my Extreme network core (very basic network). the Vlans are routed on the gateway which is our UTM appliance (handles WAN/ VPN public traffic etc). I would like to create a new set of VLANs on the core with ...

Notification for new XOS Releases

Can someone tell me where or how i have to configure/register for notifications, that a got a mail or notification when a new xos firmware (new release & patch release) is available? For Enterasys products this works more or less good, but for XOS I ...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN