ExtremeSwitching (EXOS/Switch Engine) - Page 783 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

MSTP between 2 regions

Hi, I have two sites in my network, each one with a different region of mstp, each one with domains that don't contain the same vlans. Now I want to connect both sites by a layer two connection and share some new vlans so I create a new mstp domain...

BD 8810 - upgrade to 10Gbps

Hi, can anyone let me know what is required to upgrade a BD 8810 (purchased 4+ years ago) to run ports at 10Gbps? Which hardware parts/firmware requirements? Regards, mark

eaps and mlag

Hello extreme guys is it possible to configure a MLAG ISC-Link over protected eaps? Or are there any technical issues? Thanks a lot for your reply.

OSPF Troubleshooting quesitons..

The problem right now is that our outbound traffic is only using one of our many MPLS pipes. And i reckon this is because there is only one advertising router for those networks. 1. We have multiple ISP routers redistributing routes (they say they d...

Eaps blocks both primary and secondary port for only one protected vlan

I noticed on one of our core switches (X480-24x(10G4X)) - which is eaps master for the given ring - that it had blocked one vlan wrongly. Eaps status is Ok, and shows that secondary port is correctly blocking while primary port is open and forwarding...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN