ExtremeSwitching (EXOS/Switch Engine) - Page 791 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

OSPFv3 via Vman hangs at EX_START

Hi folks We had two X450a with core licence connected directly with a cable that was user for OSPFv3 peering. that worked perfectly. Now we had to put some other extreme switches in the middle that transport this via a VMAN. since then OSPFv3 state i...

UPM Help

Hi, Trying to configure a UPM profile for multiple devices based on device_detect. However not having much luck. Example below: IF ($MATCH($(EVENT.NAME) , DEVICE-DETECT) ==0 ) then IF ($MATCH ($(EVENT.DEVICE_MODEL) , AP8132) == 0) then Configur...

X460...

Create Date: May 9 2012 1:10AM From top command is currently 90% bcmDPC. BcmDPC go upsometimes in the? The service has no effect on current symptoms, but the CLI screen much slower happened. State. (from yong cheol_Doo)

Routing between virtual routers

I'd like to revisit the question of "how do I route between virtual routers". I'm in a managed datacenter environment and have 8806s, 480s, 460s. all running XOS 15.3 or higher. Scenario: I have a dozen or so corporate-internal VLANs that are all co...

Added unused/new switch to stack now I get pending-aaa on console port

I added another x440-48p to my existing stack. I did not set up the existing stack. I enabled and synched the new node, but I get the "pending-aaa" prompt on the console port. Rebooting did not help. As I recall the only difference in the switch's w...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN