ExtremeSwitching (Other) - Page 110 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

stacking 460g2 with vim-2x

I am trying to stack two 460g2 via VIM-2x modules with exos 16.1.3, and have cabled them the VIM modules from S2 to S1 and S2 to S1 and they show link lights but do not form a stack. This works fine on the front panel ports but not the VIM. I noticed...

2016-10-17: New GTAC Knowledge Articles October 09 - 15, 2016

Here are the new articles that were published October 09 - October 15, 2016 in GTAC Knowledge: Sunday, October 09, 2016: Client not keeping DHCP address Monday, October 10, 2016: How to change the Report PDF Orientation in Netsight? Does Netsight s...

enterasys xp 2400-256

when the router boots up and you run the show command the Ethernet ports show as being disabled, however when you plug in an Ethernet cable the port comes up. is there a way to enable the ports, and change the admin state, as the show port status say...

2016-10-03: New GTAC Knowledge Articles September 25 - October 1, 2016

Here are the new articles that were published September 25 - October 01, 2016 in GTAC Knowledge: Sunday, September 25, 2016: How to change the support portal password? Monday, September 26, 2016: How To Configure PBR on EXOS for NAC Integration wit...

x450-G2 won't boot after enabling stacking on master

Hey folks! I'm working on a stack of (3) X450G2-48p-10G4 to replace our old X350 user stack. The new switches have 16.1.0.18 on them from the factory. I enabled stacking and the switches rebooted, but (what should have been) the number 2 switch di...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN