ExtremeSwitching (Other) - Page 166 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Cisco 2602i compatibility issue ?

We're installing a Cisco 2602I based wireless solution onto a B5 three switch stack and some of the switch ports are refusing to come up when an access point is plugged into them. Checking the inlinepower status shows that the switch is providing ~4W...

Log message: port: notice: port 23 under current

I searched and searched, and could not find anything. What does this log message mean? I assume it has something to do with PoE. Do I need to do anything to correct this? If not, how do I filter this message? I was unable to find a log filter ex...

link aggregation, two links, two streams, yet only single bandwidth

The setup is simple: There's a backup server using HP Teaming software to form a LAG of two gigabit copper ports with a 7100 using LACP. Establishment of the lag works fine and the aggregate bandwidth is shown correctly as 2Gbps. Now I know what a si...

port shows as forwarding even when disabled

On 7100 v8.22 I see the following: ->show port status ge.2.3-4 Port Alias Oper Admin Speed Duplex Type (truncated) Status Status (bps) ------------ ---------------- -------- ------- ------ ------- ---...

DHCP snooping question and clearing routes

On Extremeware, v7.8 (platform doesnt matter but lets call it a 7i), where is the DHCP snooping command? Is DHCP snooping possible on extremeware? And, on XOS, how do we clear the OSPF routing table? On Cisco it would be I believe clear ip rotute ...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN