This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
ExtremeSwitching (Other)
Questions and discussions about switching in general
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Start a conversation

Derive CoS values from DSCP values / QoS Questions

Hey Folks! today i was working with classifying / marking traffic on the A2/A4/B3/B5 Platforms (latest Firmware). Basically i want my QoS Setup based on DSCP values, because its end to end. As far as i could figure out, ETS switching does its prio...

dirk by • New Contributor II
  • 4333 Views
  • 8 replies
  • 2 kudos

show multiauth on SecureStack B3

How can I to know which users and IPs address are connected in the ports in the CLI on SecureStack B3 CLI? Like in the Port Usage --> columns Session ID, User Name and Ip address on Policy Manager? On switches Cisco, I use "show authentication sessio...

S1- Hardware Utilization (IDLE)

Hi friends, I have a problem, I have a s1 with approximately 1200 users, sometimes the computer processing up to 95%. In the show I can see that support the process up is one called "IDLE" I wonder which may be ocacionados this problem.

cpu light red

A4 Cpu light flashes red and all the lights for the connecting computers are off. Can’t login by console port. Unplug the power and restart the switch. The fault goes recovery and the switch is working on. But after a few hours, the fault is co...

GTM-P2G8KFN