ExtremeSwitching (Other)
Questions and discussions about switching in general
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Strange Performance Issue on X450-G2

I have a strange performance Issue on a X450-G2-48p-10GE4, i suggest some kind of interoperability issue, but I’m not sure what causes it. I cannot see any hint of a root cause.When connecting a (new) computer on some ports, although getting 1000Mbit...

CFaber by New Contributor
  • 4 replies
  • 0 kudos

Does 210 series support Ipv4 to IPv6 Transition Mechanism (Dual Stack on HP 2530) and Virtual Stacking (Virtual stack is a technology that provides centralized management for up to 10,000 switch ports.)?

I am checking 210 series specs against the HP 2530 which says it support Dual Stack and Virtual Stacking that says it can provide centralized management for up to 10,000 switch ports. Which confuses me because when you say stacking the stacked switch...

chformes by New Contributor
  • 0 replies
  • 0 kudos

How to replace a failed switch in a stack?

I have two x460-48t switches configured in a stack. I want to create a procedure for replacing one of them if it fails. I searched and found a similar question from a year ago. But the document that was offered as a solution is no longer available to...

Resolved! Additional LAG ports in a stack

Hello.I am new to the community and this is my first post.I am considering placing an older X450e-24p in an area where I need 12 additional switch ports (4 ports need PoE). The edge stack consist of four X440G2-48p switches and has LAG ports going to...

Lynden63 by New Contributor
  • 1 replies
  • 0 kudos

Resolved! configuring eth ports

HelloI have an AP330 and I have successfully configured it as a WIFI access point. I would also like to configure eth0 and eth1 as follows:I would like to connect eth0 to my router (which is also a DHCP server)I would like to connect eth1 to my deskt...

Gtcg by New Contributor
  • 2 replies
  • 0 kudos