ExtremeSwitching (Other) - Page 32 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Resolved! B5 and S-Series switch policy profile with multiple rules

I’m assuming this is possible but I’m not sure how to do it.For example based on the GTAC guide “How to Block Bonjour traffic with Policy via Command Line Interface” I know how to drop this IPv4 traffic.I would like to add to this existing rule anoth...

Resolved! Tranciever Information not clear with "debug hal show optic-info port 1"

Hi community, Customer was asking to get an overview about what optics he have in use for a specific campus.I checked that with command:“show port config no-refresh” and got:GERMUESW038.1 # show port 1 config no-refreshPort ConfigurationPort Virtual ...

ADT and ERS8600

I am trying to use ADT to discover the ERS8600 switches but it is highlighted in red although the credentials are correct and we can discover these switches with JDM normally from the same machine. So, I need to know if this model is supported with A...

How to change a SOK1208-0204 Module of a S-SERIES S155 Module

Hello everyone,i tried to exchange a SOK1208-0204 module of a S155 (S4), unfortunately without success. I can't separate the module from the S155. Is there a trick there? In the installation manual there is nothing about brackets or similar. We have ...

"application protocol error" returned for every show command on VDX 6740 NOS CLI

Hello Community,I am a bit new to NOS. Hence, I am having a weird issue with a single VDX 6740 NOS switch running VCS technology. I can login without issues but whenever I type in any show command, I get the error message below.NOS-SW-01# show runnin...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN