ExtremeSwitching (Other) - Page 80 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Resolved! How can I troubleshoot the poe switch. all ports suddenly shut down.

How can I troubleshoot the poe switch. all ports suddenly shut down. the main problem is it was stacked to other switches. I don't know how to configure it in master slot 1. or are I going to pull out the defective switch then how to troubleshoot th...

(pending-AAA) login:

I pulled out a switch from stacking it is a STANBY mode. But now this is the scenario. (pending-AAA) login: Warning: the stack has no Master node and all active nodes are operating with master-capability turned off. If you wish to reconfigure...

Can't Access Switches With Loss To LDAP via NAC

Hi, Currently have all switches in the network doing management login via Radius Via NAC and then onto LDAP to AD. The problem has arisen, although two AD (LDAP Connections) have been configured, where Full loss to both the LDAP services has occurr...

debug packet capture not working

Hi,Just trying to run a debug packet capture on the following:Stack of 4 x X450G2-48P-10G4, running version 22.2.1.5-patch1-4As per the following GTAC articles:https://extremeportal.force.com/ExtrArticleDetail?an=000079573 (This article is slightly w...

Is the ReachNXT 100-8t compatible with Summit 620 and Summit 670-G2 switches (XOS 21.1.3.7) ?

Hi, We would like to use these to connect a one or two low speed ports (10/100Mb) to our 620/670G2 switches running XOS 21.1.3.7. Has anyone run the ReachNXT 100-8t with these units? I cant find any clear documentation saying yes or no.

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN