ExtremeSwitching (VSP/Fabric Engine) - Page 24 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Resolved! Fabric Extend through wireless bridge but keep management IP addresses for bridge elements

Hi,We recently create L3 fabric extend logical interfaces to extend fabric through a wireless bridge following this article: How To: How to configure L3 Fabric Extend on VSP4K and VSP7/VSP8K. | Extreme Portal (site.com) Logical interfaces were esta...

Swapping fibres in VSP SMLT to EXOS LAG = SMLT port down

I have 2 VSPs, VSP1 and VSP2 that have SMLT fibre connections to EXOS switch stacks that use sharing.I built a new EXOS switch stack to replace an existing one, created a new SMLT and all that worked fine. I then disconnected both fibres from the exi...

Captured traffic inconsistently VLAN-tagged

Hi all,I set up traffic monitoring on VOSS and EXOS switches, but the network analysis guys are complaining that captured traffic is asymetrically tagged, and this messes up with their software.On the EXOS switch, traffic is captured on selected port...

Resolved! VLAN Isolation

Hi,we want to redesign our vlan architecture and move from location based vlans to device based vlans ( e.g all printers in a one vlan ). I would need to create the vlan on 35 VOSS Access Switches and our 2 Core Switches.The thing that is buggin me i...

Is there a way to schedule a restart on a VOSS switch remotely?

I have a switch at a remote location that should only be restarted after hours, and it would be extremely helpful if there is a command out there that allows this. I have looked in the VOSS command line interface for schedule (not doing energy-saver...

Top Kudoed Authors

User

Count

37

21

21

18

8

GTM-P2G8KFN