Network Architecture & Design - Page 10 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

Resolved! How to configure NAC to send outbound radius attributes for dhcp snooping, bpdu filtering, slpp guard

What configuratoin is required to setup NAC to send outbound radius attributes for configuring ERS4900 with FA radius attributes like: dhcp snooping bpdu filtering slpp guard IP-Source Guard All this should be possible in combination with NAC and ERS...

Fabric Comparison

Hi Community I am looking for an Extreme Document comparing the Extreme "Automated Campus Fabric" with Cisco's "SD Access Fabric" and Aruba's "Dynamic Segmentation Fabric". Does Extreme have such an comparison available that can be shared with the ...

Remove primary iproute and inject secondary iproute when primary path is unavailable; then reverse when primary path is available

I'm trying to inject a static route 192.168.12.0/22 192.168.11.253 when gateway 192.168.8.12 fails. When 192.168.8.12 is once again available, I would like to remove the 192.168.12.0/22 192.168.11.253 route and replace it with 192.168.12.0/22 192.16...

OSPF establishes adjacency, but no routes are exchanged

Hi, a customer had a relatively common problem concerning OSPF, but did not find the solution searching the web. This post is supposed to help others find the information that is already out there. OSPF was configured between two Extreme Networks s...

Resolved! Allowing only one end-system per domain user?

Hi all, Short background info : On our network, users authenticate for wired and wireless network with 802.1X. The users and computers are retrieved from our Domain controller. The AD is the primary radius server linked to 2 NAC virtual appliances, ...

Top Kudoed Authors

User

Count

4

3

3

3

2

GTM-P2G8KFN