Network Architecture & Design - Page 44 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

Fiber connection from switch to server-No Link

Hello Everyone, I have an Enterasys B5K124-48P2 with a FTLX8571D3BCL-EX SR SFP+ module installed in port 49. On the other end is a Lenovo 650 with an Intel x520 card and an Intel FTLX8571D3BCV-IT module. I am using MM 50/125 Tripp Lite patch cable. ...

Risks When Upgrading from EXOS v12.5 to v16.1?

I have installed EXOS ver 16.1.3.6-patch1-9 in the free partition of device which has current firmware 12.5.4.5. I haven't rebooted yet. My questions is, 1) Is there any possibility to crash the config file when rebooting ? Note: This conversation ...

spanning tree protocol

I have disabled spanning tree everywhere on vlans, interfaces yet when i generate PFC pause frames some spanning tree packets are also captured. Can anybody help me how to turn them off. following is the capture of wireshark: 0.045006 ExtremeN_97:e...

Why do you assign a VLAN to a virtual router, and not an interface?

Hi, I'm trying to understand why you assign a VLAN to a VR, instead of an interface, which is what I you would expect. Why does EXOS work that way? How I would imagine it to work: * Create user VR-A * Go into VR-A and say "i want it to have an inte...

Cannot make iBGP peering over IPv6 across two Extreme X770 switches running 21.1.2.14

Hi Experts I can't make an IPv6 iBGP peering up across Extreme switches, connected back to back. IPv4 peering is working fine. It appears Extreme has some recurring issues with IPv6 configuration. I tried turning on and off BFD options, still it do...

Top Kudoed Authors

User

Count

4

3

3

3

GTM-P2G8KFN