Network Architecture & Design - Page 50 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

How to test 10g circuit?

We have an x480 with a 10g connection to our provider. Optics are 10g multi-mode to our providers equipment. What would be methods of testing this circuit? My laptop only has a gig nic. There are no rx, tx, collisions or congestions on the port o...

EXOS using MSTP, port Vlan change breaking spanning tree!

Edited with more detail................. In EXOS using MSTP there is no means of directly mapping a Vlan directly to an MSTI or configuring a port as edge or point-to-point, until you associate a Vlan to port – which causes a few problems: 1st ...

802.1x Authentication Problem

Hi,I have Enterasys B5 Switch. My switch configures 802.1x authentication as Extreme Networks video(https://www.youtube.com/watch?v=V8lMAMqLYmk) I connect my computer on switch port. My computer has an access to network without authentication. UPlink...

mac based vlan , multiple edge switches .

Configuration of mac based netlogin , when vlan spread over a number of switches. I am trying to limit the mac addresses that access a number of switches on the same vlan , from reading the Guides I understand the concept .. just putting this into p...

meter almost works for me. No counters via cli, via snmp, no snmp traps

Hi I have xos 16.1.3.6-patch1-8 on my summit670. Try to use meter as an ingress shaper to limit udp and icmp flood. Shaping seems to work but problem is with notification. As far as i tested, only syslog message works. Counters via cli still show 0,...

Top Kudoed Authors

User

Count

4

3

3

2

GTM-P2G8KFN