Network Architecture & Design - Page 57 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

Console Connection to an x440-8?

Excuse my ignorance, but I am having my first experience with an x440-8. Can I ask how do you console to the device? I need to complete the initial configuration of the device and can't seem to figure out how to connect to it. Thanks, Stan

Error: ACL install operation failed - filter hardware full for vlan esn-mo-01, port *

Hi there,I'm trying to implement a new egress vlan ACL to match traffic going to a particular address on a range of UDP ports and put it into QoSprofile QP6.But I'm getting the above error.I'm on an X460 running 15.6.3.1 and I appear to have egress A...

Design High Availability with two switch core Summit 460-24P

Hello and good morning I have a doubt about a design for an small network, consist in two stack one for data and one for voice, those stack are connect it to a switch core, so i want to put another switch core for redundancy and high availability, so...

MEMBER SWITCHES IN STACK UNABLE TO ACCESS NETWORK

Hi Guys, I recently replaced a faulty B5 Switch which was manager in a stack of 3 switches, I turned off all the switches before taking out the old one. I configured an installed the new switch using a backup file of the previous switch. Now after ...

How Can I check if my equipment have a warranty valid?

We have 22 Summit X350-48T and I need check the currently warranty status.

Top Kudoed Authors

User

Count

4

3

3

3

GTM-P2G8KFN