Network Architecture & Design - Page 58 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

Restoring Backuped Configs to EOS based B5 Switch using. TFTP

Hi Guys, I am having a challenge restoring backed up Configs of some of my B5 Switches saved with netsight. My challenge here is there is no communication between those switches and netsight to restore from netsight. Those switches were fault...

Console Connection to an x440-8?

Excuse my ignorance, but I am having my first experience with an x440-8. Can I ask how do you console to the device? I need to complete the initial configuration of the device and can't seem to figure out how to connect to it. Thanks, Stan

Error: ACL install operation failed - filter hardware full for vlan esn-mo-01, port *

Hi there,I'm trying to implement a new egress vlan ACL to match traffic going to a particular address on a range of UDP ports and put it into QoSprofile QP6.But I'm getting the above error.I'm on an X460 running 15.6.3.1 and I appear to have egress A...

Design High Availability with two switch core Summit 460-24P

Hello and good morning I have a doubt about a design for an small network, consist in two stack one for data and one for voice, those stack are connect it to a switch core, so i want to put another switch core for redundancy and high availability, so...

MEMBER SWITCHES IN STACK UNABLE TO ACCESS NETWORK

Hi Guys, I recently replaced a faulty B5 Switch which was manager in a stack of 3 switches, I turned off all the switches before taking out the old one. I configured an installed the new switch using a backup file of the previous switch. Now after ...

Top Kudoed Authors

User

Count

4

3

3

3

GTM-P2G8KFN