Network Architecture & Design - Page 76 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

How to configure LLDP for Mitel and Cisco phones on an Extreme X-series switch (X440, X460, etc.)

create qosprofile "QP6" enable diffserv examination port enable dot1p replacement port configure qosprofile QP6 maxbuffer 100 weight 1 configure qosprofile QP6 minbw 0 maxbw 100 ports configure diffserv examination code-point 46 qosprofile QP6 con...

How to configure LLDP for Avaya phones on an Extreme X-series switch (X440, X460, etc.)

Enable LLDP: code:enable lldp ports Enable LLDP Media Capabilities: code:configure lldp port advertise vendor-specific med capabilities Enable ports to advertise vlan-names: code:configure lldp port advertise vendor-specific dot1 vlan-name vlan ...

Help with setting up LAG with LACP on Extreme and Procurve

Hello, I'm wondering how I should setup a configuration between Extreme and Procurve. On the HP, it looks like they have "static or dynamic", and "active or passive". I'm assuming to create this LAG between the two switches that on the HP I would ...

Resolved! Scan network for vlan info.....how to

Our network has grown, and through the year vlan standards have not always been consistent/followed. At our disposal are the standard tools (snmp, port scans, etc) and Ridgeline v4 and Epicenter. Are there any tools any one knows of that can scan o...

OPSFV3 for IPV4

Dear All, I am trying to configuration OSPFV3 for IPV4 . But no idea how to do same on extreme OS(ExtremeXOS version 15.3.3.5) / Like in juniper its call realm ( So we have one control plane for bothe IPv4 and IPV6) https://njetwork.wordpress.co...

Top Kudoed Authors

User

Count

4

3

3

3

2

GTM-P2G8KFN