Network Architecture & Design
Questions and discussions about network architecture and design in general
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

A-Series Switch VLAN Configuration

Hi, I have some queries on configuring VLAN on our network having the combination of Enterasys A series & C5 series switches which is connected to CISCO 3650 via CISCO ASA Firewall (Refer the below schematic network diagram) We need to create VLAN2...

aeac4a1f77004ed0bb884a239bd5e3f7_RackMultipart20151020-12022-tmxwl0-VLAN_Config_Query_inline.jpg

Rear facing switches - heat problem

Hi guys, you have been a lot of help to me in the past and I have one more "unusual" question for you... Now, I am sure some of you might have had to install a bunch of switches rear facing to avoid many cables coming from the back of the servers t...

Localhost by โ€ข New Contributor II
  • 1888 Views
  • 4 replies
  • 0 kudos

EAPS

Hello,I have a set EAPS ring between three points interconnected with radios. However the customer must include an optical fiber, as another option of redundancy / balancing. What would be the best way to configure this scenario?

Felipe by โ€ข New Contributor
  • 2302 Views
  • 13 replies
  • 0 kudos

New APs and poor load balancing

We are a school, with two C25 controllers (I'll call them A and ๏˜Ž serving about 45 3705i APs, deployed about one per 2 or 3 classrooms. All classrooms get decent signal strength (-50 to 60 dBm or higher), usually from multiple APs -- but we are incre...

GTM-P2G8KFN