Network Architecture & Design - Page 86 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

Installing both Ridgeline and NetSight on Same PC

Hi I installed Ridgeline 4.0 with SP2 and worked fine on my Laptop. I used port http://my-pc:9090. then I installed Netsight on the same Laptop and accepted the default setting (assuming port 8080). When Netsight installation was done and tryied (h...

GTAC Knowledge new articles June 12, 2015

Here are the articles that have been published this week (June 8 - June 12, 2015) in GTAC Knowledge Friday June 12: XSR Reboots Intermittently Poor performance on the 3825i or any 38xx series access point with TKIP enabled Wireless Clients are get...

Netsight Console discovers only one device in one IP Range Vers. 6.2.0.211

Hi Experts! From one day to another i've got a Problem with discovering devices with Netsight console. The discover finds in different IP-Ranges only one Device and not more. Yesterday I hadn't any Problem with discovering Devices!! If i add one of...

reset 800 series factory defaults

Hi there! I recently got a 08G20G2-08 and after setting some basic configurations through the web console, I am now unable to get into the switch either through the web console or ssh. I don't see a factory reset button on my switch so I am wonderin...

Stack and uplink ports X440 x460

Hello, i need to connect two stack [2x X440-24p-10G] and [3x x460-48-10G] with core 7100 switch. My problem is to share 10Gb ports on (x440/x460) one for stack and one for uplink - is that possible or both ports have to be stack OR uplink in the sam...

Top Kudoed Authors

User

Count

4

3

3

3

GTM-P2G8KFN