Network Architecture & Design - Page 87 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

QoS ACL To Re-Mark DSCP

Hi all I want to re-mark to DSCP zero any traffic coming in which is outside of a particular UDP & TCP port range. I'll need to use an ACL but would I have to list every single port in the range - I don't think I can use < > symbols in a policy can...

Basic ACL: Switch says ACL doesn't exist when I created it, please help.

Hi Everyone, I'm trying to create and apply a ACL to a vlan on my switch but when I run the commands it says it doesn't exist. 1. I created the policy by entering: vi PBR_DEFAULTROUTE.pol I enter a simple a entry and entered :wq! to save. successf...

Default behavior of Extreme switch when MAC table is full

Hi everybody Let say we have a switch with mac table max address =45 . Assume mac table is full, let say another frame comes into the switch whose source mac-address and destination mac are not in the table. 1)Will switch overwrite the oldest mac e...

ERRDISABLE EXTREME NETWORKS STP LOOP PREVENT

Hello all, I would like to know if its possible create loop prevent with ports on the same switch (X450E 48P) For example: Vlan default ports 1-16 tag 1 Vlan RH ports 17-32 tag 10 Vlan adm ports 33-48 tag 20 ipfowarding enable... If simulate loop b...

Voice and Data Vlans

I need to setup a switch (X460P) to be able to use a VOIP Phone (Polycom) and to be able to use a PC also. The PC MIGHT be plugged into the phone, or there may not be a phone at all, just a PC plugged into a port. All ports on the switch would need...

Top Kudoed Authors

User

Count

4

3

3

3

GTM-P2G8KFN