Extreme Networks

Hans · 05-06-2022

We want to create an IP Firewall rule in the IP Firewall policies to allow traffic only to an IP-RANGE. However it seems we only can configure a hostname or an IP-address, not an entire ip-range. Is this correct?

Hans · 04-13-2022

Is it still possible to import a CSV to create multiple PPSK's based on internal users? It seems I only can import a CSV that is exported from XiQ (classic). I want to create a fresh CSV that I can import.

Hans · 07-27-2021

HelloAt one of our customers the access points are not syncing with the NTP servers, wich gives problems at using authentication. When we run show ntp we get the default [number].aerohive.pool.ntp.org servers. However when we using the command show c...

Hans · 07-14-2021

HelloI have a customer with a lot of DFS events. I want to check the channel that is experiencing the DFS event. However, I can not find this information, not by the GUI (ExtremeCloudIQ) and not by CLI. Any idea? I see DFS events at all of our custom...

Hans · 06-15-2021

Our Zebra scanners does not roam on Extreme AP305C access points when using WPA2 enterprise with FTE (802.11r). However there is no problem with other Extreme access points. Packetcaptures show status code: Invalid FTE (0x0037) in the reassociation r...

Hans · 02-20-2023

Hello IgeanNo problem to support AP121's in the Extremecloud IQ. We support some environments with the AP121. There could be some features not working properly, however we did setup features as GRE tunnels without any problem. Offcours not a bad idea...

Hans · 12-06-2022

Hello Deepak. Always check the channelbonding, the Extreme AP510C is probably configured for 20Mhz channels as the other AP's will be configured for 80Mhz channels.

Hans · 05-06-2022

Hello SamWe already tried this, however you can not use the IP-range (only an hostname, ip-address of a host or network (not range)) in the firewall policy.

Hans · 03-09-2022

Same issue here, alle tests are fine however no RADSEC proxy AP elected. We are using AP130's with firmware 10.4.3.0.

Hans · 12-14-2021

Hi Florionif you are using a 2x2:2 device in a 40Mhz channel with the 802.11ac PHY the max is 400Mbps datarate, you may disagree however it's WiFi science ;), you can check the datarates table on this http://mcsindex.com. You need at least 80Mhz cha...

Extreme Networks

User Statistics

User Activity

IP Firewall Rule - IP range

Import CSV to create bulk PPSK

NTP issues AP250

DFS interference

802.11r - Invalid FTE

Re: AP121 compatible with XIQ?

Re: 5AP510c limiting download speed to 170Mbps, when i connect to other brand AP i get 450+Mbps down

Re: IP Firewall Rule - IP range

Re: There is no RADSEC proxy enabled for the network, though port 2083 test is successful. Is there anything else need to be allowed from Firewall or in hivemanager for PPSK to work?

Re: Low data rate in 5ghz netwrork