Wireless (General)

Ronald Dvorak posted 10-02-2021 11:56

Hi Pedro,

have you’ve tried to rediscover the controller in the NSM ?!

If you tell me where the option "publish APs as interfaces" is in the VE controller I’d try it in my lab….. I’ve searched a while but I’m not able to find the option in the GUI :-)

 

-Ron

Pedro Pereira posted 10-04-2021 10:45

Hi Ron, 

Thanks for answering. 

have you’ve tried to rediscover the controller in the NSM ?!

yes, I got the same result

If you tell me where the option "publish APs as interfaces" is in the VE controller I’d try it in my lab….. I’ve searched a while but I’m not able to find the option in the GUI :-)

It was in the aba Controller > Network > SNMP and there you have an option saying “Publish AP as interface of controller” and 2 options “Enable” or “Disable”

StephanH posted 10-04-2021 13:31

 

Hello Pedro,

I can't find the setting despite your description. I don't know any "Controller" menu.

Do you have an screenshot?

Ronald Dvorak posted 10-04-2021 14:13

I can see the option on a V2110 (Identify) controller but not on a VE Campus Controller…. so what model are we talking about ?!

-Ron

 

Ronald Dvorak posted 10-04-2021 15:12

You’d enable it on the VE campus controller via CLI - I’m pretty sure that this isn’t supported but you’d try it :-)

 

 

I was not able to test it as my XMC is a little stubborn.

In case if that works I don’t know whether the value get’s overwritten to disable during a SNMP config change/reboot/upgrade.

-Ron

StephanH posted 10-04-2021 15:40

Basically, there is the statement from Extreme Support. Configuration changes on the CLI are not officially supported.

Therefore there is no CLI guide for the XCC.

Because of this basic requirement, for example a "SAVE" in the GUI can lead to the configuration via the CLI disappears, is changed or dependencies of the CLI commands are dissolved.