Hi, I got a S4 Chassis and a X670 I configured vrrp vrid 1 on both of them. S4 (Master): interface vlan.0.200 ip address 10.33.1.2 255.255.255.0 primary vrrp create 1 v3-IPv4 vrrp advertise-interval 1 centiseconds 20 vrrp priority 1 priority 200 ...
Hi community, I have a Summit48si and need to monitor port errros like CRC & collisions. I see from MIB files there are following OIDs available: - extremeRtStatsCRCAlignErrors extremeRtStatsCRCAlignErrors 1.3.6.1.4.1.1916.1.11.1.1.3 - extremeRtSta...
Is there a difference between these two switches when configuring LACP? We replaced a B3 with a B5 switch with identical configuration and the LACP ports appeared to create a loop. The only difference between these two units (besides model) would be...
My customer have serveral small 800 series switches. Currently we cannot access web interface because recent browsers (firefox / chrome) deny the used out-dated ciphers. Researching last available firmware / manual confirm there are only out-dated...
Hi, I am having issue with 08H20G4-48P lately. After a few power outages the switch does not forward any traffic. I can access it remotely via Web GUI and via ssh without any problem. But I can't access any other devices that are connected to it. Al...
